You are here: Experiment Guide > Imaging Modes > Piezoresponse Force Microscopy > Write an area in the piezoelectric sample

Write an Area in the Piezoelectric Sample

Using the ferroelectric properties of piezoelectric materials, we will now write an area.

  1. Set the following Scan parameters:
  1. Change the Aspect Ratio to 64 to write a small strip.
  2. View the LS PR Phase channel. 
  3. Set the RealTme Plane Fit to None.
  4. Set the Tip Bias to 10 V to write the area:

  1. After writing the area, turn off the Tip Bias by setting it to 0 V.

Previous Step:

  1. Piezoresponse Procedure Set Up

Next Steps:

  1. Image the Written Area
  2. Optimize the Image
  3. Simultaneous Multiple Optimizations

 

www.bruker.com Bruker, Inc.
www.brukerafmprobes.com 112 Robin Hill Rd.
http://nanoscaleworld.bruker-axs.com Santa Barbara, CA 93117
   
  Customer Support: (800) 873-9750
  Copyright 2010, 2011. All Rights Reserved.